Tuesday, November 9, 2010

A cradle for changing router bits on a Triton router

I got tired of chasing my big router around the bench when changing bits or setting depth of cut so today I grabbed a piece of 1 x 4" and a chunk of 1/4" mdf and made a cradle.
I traced around the router and cut the MDF out in a rough pattern on the bandsaw then tuned it a bit with the spindle sander.
From wood stuff 2009
Next I put a brace inside to support the router top and covered it with a bit of foam to prevent scratching.

Heres the finished cradle held on the bench with a couple of clamps.

From wood stuff 2009

I can reef on the change wrench without having to embrace the tool each time I change the bit.

From wood stuff 2009

Could have been fancier but it works.

Bob

No comments: