I needed a jig to allow me to cut consistent thin strips away from the fence and the potential for binding and possbly nicking the fence. I have the Grr ripper but sometimes need a strip too narrow for this jig.

I saw this in Shopenotes or similar and never got around to making it.
It's really simple and only needs a routed slot and a bolt to carry a small bearing on the nose.

From THINS STRIP TS JIG

I picked up the miter slot fittings from Workshop Supply here in Canada.
You can fine tune this with measuring bars and cut strip after strip just by moving the fence in to the bearing surface.

From THINS STRIP TS JIG

From THINS STRIP TS JIG

From THINS STRIP TS JIG

From THINS STRIP TS JIG

If you use the Grr ripper you can set it way back and set the gripper up ahead of it to carry the cut through the blade.

Bob